Configuration Minimums Operators: 1). Operator Section - all sections, Antenna: optional 2). UI/Macros Enable Two Scheme 8 Enable "Load last used macro file on startup" Enable "Display macro filename on startup" Enable "Prompt to save macro file" 3). Modems/MT-63 Enable 8-bit extended characters, Long receive integration, 1 second Tone Duration Manual tuning 4). Soundcard/Devices Enable PortAudio Select Capture device Select Playback device Disable Device supports full duplex Be sure soundcard is calibrated (CheckSR.EXE or WWV) 5). ID/RsID Enable "Medium" Allow Errors Pre-Signal Tone = "4.0" seconds Enable tx freq lock Squelch open (sec) = "0" 6). Set SIG levels so that in TUNE the signal just fits between the two gray lines 7). Before the net begins all operators should fill: The "In" box with 0 or the number of messages they wish to send. The "Out" box with their transmitted power level. Note: These macros can be found at: www.k1hil.org